#229 • Shop Built pneumatic hydraulic 15 ton press with computerized control switches

Part of Shooting Target Manufacturer Auction (timed auction by AuctionAZ.com, LLC)

High bid $1,301.00

Status: Sold

Category: Shop Machinery and Equipment

15% BUYER'S PREMIUM Shop Built pneumatic hydraulic 15 ton press with computerized control switches * Computer controlled: automatic and manual modes * Dual, Miller 15.5-ton hydraulic cylinders (31,420 lbs force each) * 4 HP Gast, pneumatic motor * Dual UNITTOOL punches * Custom designed press break with industry-standard frame and workbench * Like new, built in 2020, less than 4 hours of operation time on it The press brake accepts standard punches/rams and bottom dies. Changing out dies is easy: two set screws for the top die and the bottom die sits in the workbench channel. The back gauge is adjustable. Includes extra V-dies and punches. This press is driven by a 4 HP pneumatic motor. It requires at least 30-40 CFM of air flow (7+ HP air compressor), but it's intermittent flow, not continuous.  That was a design goal in order to be as energy efficient as possible because the press was used sparingly. I wrote the code for the microcontroller in ANSI C; it's about 600 lines of code. If you're a programmer, I will also provide the code for the 8-bit AVR Atmel chip.  All the development tools are free and open source.  I can offer consulting to modify the code for specific applications if need be.  Otherwise, manual mode should suffice. Much of the electronics are still on a prototype board, which has been working fine for a couple of years. The critical power components are already soldered on daughter boards; however, all  

Shop Built pneumatic hydraulic 15 ton press with computerized control switches